Get The Edge with a Bracket Mate. The tool designed to assist with the installation of electrical & mechanical containment, setting out drill points for the installation of trapeze brackets & Unistrut. Using a Bracket Mate achieves a quicker, easier and an overall far better quality install

The drill points are measured from a fixed centre line. Therefore, those drill points marked using the Bracket Mate tool will always be perfectly aligned and parallel

The numeric markings on each measuring piece have been set to account for the 20mm difference needed per end for the square washer to sit flush at each end of the Unistrut (40mm difference total)

The Bracket Mate locks at 90° & 45° for corners and also folds for easy storage and carriage

We all know that measuring and squaring up drill points of each bracket is a pain, especially when you rely on the previous point being spot on, which if not, then creates an accumulation of errors. It's tedious and time consuming...

Bracket Mate is the solution to these issues

Less measuring required ✓
No accumulation in errors ✓
1 tool needed instead of 3 ✓

These 3 factors make a massive difference with saving time and effort

See illustration...

For the purchase of more than 5 units or wholesale purchasing, please email us: bracketmate@outlook.com

>>> BRACKET MATE FACEBOOK PAGE <<<